Mechatronic Products Sensors Pressure distribution measurement system Super thin pressure sensor 6 DoF force/torque sensor   HOME > Products > Mechatronic Products and Sensors > Sensors > Pressure distribution measurement system > System Configuration > Sensor Connectors This connector is used to connect sensor sheets. The sensor connector converts the electrical resistance of each sensor cell into a digital signal, and sends it to the interface board or the parallel/serial interface module. Specifications of the sensor connector for the parallel/serial interface module are different from those for the expansion interface. System Configuration Top Sensor Sheet Sensor Connector Interface Part Software List of Recommended PC Models Resolution: 8 bit Sampling rate: 10 msec (per frame) at maximum Size: W: 57 mm × D: 135 mm × H: 35 mm Cable length: about 3 m Weight: about 320 g Resolution: 8 bit Sampling rate: 125 msec (per frame) at maximum Size: W: 57 mm × D: 135 mm × H: 35 mm Cable length: about 3 m Weight: about 320 g Resolution: 8 bit Sampling rate: 500 msec (per frame) at maximum Size: W: 57 mm × D: 135 × H: 35 mm Cable length: about 3 m Weight: about 320 g Resolution: 8 bit Sampling rate: 1 sec (per frame) at maximum Size: W: 57 mm × D: 135 mm × H: 35 mm Cable length: - Weight: about 320 g Resolution: 8 bit Sampling rate: 15 msec (per frame) at maximum Size: W: 57 mm × D: 135 mm × H: 35 mm × 2 units Cable length: - Weight: about 320 ( × 2) g Resolution: 8 bit Sampling rate: 10 msec (per frame) at maximum Size: W: 65 mm × D: 98 mm × H: 30 mm Cable length: 0 m Weight: about 150 g Resolution: 8 bit Sampling rate: 5 msec (per frame) at maximum Size: W: 39 mm × D: 68 mm × H: 19 mm Cable length: about 3.1 m Weight: -