Mechatronic Products Automatic Tool Changer Swivel Joint GYROJOINT GYROCHANGE Interface Unit   HOME > Products > Mechatronic Products and Sensors > Mechatronic Products > Automatic Tool Changer > XC-300 In terms of load capacity, the Nitta change system XC-300 is positioned between the OMEGA IV and the XC-400. Yet despite its high load capacity it is just as thin as the OMEGA IV. As a result of careful attention to spare parts, the modules used in the OMEGA IV and XC-400 can be applied as they are to the interface of the XC-300, and consumable parts such as taper pins too were designed as far as possible to be common with those of the OMEGA IV and XC-400. For enhanced reliability and safety, the XC-400 utilizes the same chuck/unchuck sensor that is equipped as standard on the XC-400. Features and benefits: - Portable capacity of 300 kg with a large-bore cylinder, and slim, high-rigidity body - Cam lock mechanism for reliable chucking/unchucking - Safety ensured by a chuck/unchuck sensor and fail-safe mechanism - Reasonably priced, thanks to use of high-reliability, commonly used components Typical applications: - Changeover of material handling tools - Changeover of spot welding guns - Changeover of tools for taking out assemblies, presses, and formed products XC-300 Specifications: Payload capacity 300kg Allowable moment 2205Nm (22500 kgf-cm) Allowable torque 2205Nm (22500 kgf-cm) Housing diameter ø 248mm Combined profile 120mm Main body material Aluminum alloy Position repeatability 0.050mm Air pressure for Working 0.39 to 0.59Mpa (4 to 6 kg/cm²) Weight Robot side 7kg Tool side 3.5kg Electrical signal Current 3A Quantity None or 20 pins Output signal Chuck Unchuck Coupling check Surrounding Condition Temperature 0 to 60(degrees(C)) *1 Humidity 95(%) *2 ＊1 No freeze ＊2 No condensation * We have 24V common type and adaptor plates. * Brochure and instruction manual files are available in Portable Document Format (PDF). If your browser does not read Acrobat's PDF files, the Acrobat Reader is free to download here.